Al-Chemist Ungu

tentang Pendidikan dan Kimia

MAKING ESTERS



This page describes ways of making esters in the lab from alcohols and phenols using carboxylic acids, acyl chlorides (acid chlorides) or acid anhydrides as appropriate.
Making esters using carboxylic acids This method can be used for converting alcohols into esters, but it doesn't work with phenols - compounds where the -OH group is attached directly to a benzene ring. Phenols react with carboxylic acids so slowly that the reaction is unusable for preparation purposes.
The chemistry of the reaction
Esters are produced when carboxylic acids are heated with alcohols in the presence of an acid catalyst. The catalyst is usually concentrated sulphuric acid. Dry hydrogen chloride gas is used in some cases, but these tend to involve aromatic esters (ones where the carboxylic acid contains a benzene ring). If you are a UK A level student you won't have to worry about these.
The esterification reaction is both slow and reversible. The equation for the reaction between an acid RCOOH and an alcohol R'OH (where R and R' can be the same or different) is:

So, for example, if you were making ethyl ethanoate from ethanoic acid and ethanol, the equation would be:







Doing the reactions
On a test tube scale
Carboxylic acids and alcohols are often warmed together in the presence of a few drops of concentrated sulphuric acid in order to observe the smell of the esters formed.
You would normally use small quantities of everything heated in a test tube stood in a hot water bath for a couple of minutes.
Because the reactions are slow and reversible, you don't get a lot of ester produced in this time. The smell is often masked or distorted by the smell of the carboxylic acid. A simple way of detecting the smell of the ester is to pour the mixture into some water in a small beaker.
Apart from the very small ones, esters are fairly insoluble in water and tend to form a thin layer on the surface. Excess acid and alcohol both dissolve and are tucked safely away under the ester layer.
Small esters like ethyl ethanoate smell like typical organic solvents (ethyl ethanoate is a common solvent in, for example, glues).
As the esters get bigger, the smells tend towards artificial fruit flavouring - "pear drops", for example.
On a larger scale
If you want to make a reasonably large sample of an ester, the method used depends to some extent on the size of the ester. Small esters are formed faster than bigger ones.
To make a small ester like ethyl ethanoate, you can gently heat a mixture of ethanoic acid and ethanol in the presence of concentrated sulphuric acid, and distil off the ester as soon as it is formed.
This prevents the reverse reaction happening. It works well because the ester has the lowest boiling point of anything present. The ester is the only thing in the mixture which doesn't form hydrogen bonds, and so it has the weakest intermolecular forces.

Larger esters tend to form more slowly. In these cases, it may be necessary to heat the reaction mixture under reflux for some time to produce an equilibrium mixture. The ester can be separated from the carboxylic acid, alcohol, water and sulphuric acid in the mixture by fractional distillation.

Making esters using acyl chlorides (acid chlorides)  




0 komentar:

Posting Komentar